Matrix Ring Installation

Test Before Unpacking and Installing

Your light was tested prior to shipping. Please re-test before ceiling installation using the provided testing cable. If you experience any issues, stop installation immediately and contact our support team at 305.897.2209 before proceeding.

Pre-Installation Setup & Testing

1. Connect the Power Cables

Connect all power cables to the rings.
For square white connectors: ensure the flat side of each connector is aligned. If rotated 180°, the lights will not operate.
For round connectors: alignment is not an issue.

👉 Click here for Remote Setup Video

2. Prepare the Remote Control

Insert batteries into the remote.
Confirm batteries are installed correctly (+/–).

3. Sync the Remote and Fixture

Single fixture: Press the “C” button inside the remote while plugging the fixture into power.
Multiple fixtures: Refer to included remote instructions for pairing guidance.

4. Test Remote Functions

Single click down: ON/OFF
Double click down: Switch lighting zones
Rotate dial: Adjust brightness within each zone

✅ If testing is successful, proceed to ceiling installation.

Ceiling Installation Guidance

Plate Orientation

If using a round ceiling plate: confirm orientation before installation. A 90° misalignment will change ring direction.
Decide fixture layout:
- One side with Large + Small ring
- Opposite side with Medium ring
Note the direction of the power cables on the ceiling plate.

IMPORTANT: The box includes a ceiling template for marking positions of ring hangers. After installing ceiling bracket but prior to installing the ceiling plate - use template to mark locations for support cables. This does take a little patience. Blue paint tape is often recommended to hold the template in place so you can make the marks accurately.

Option A

Option B

⚠️ Power cables will hang through the middle of other rings.

Cable & Drop Length Adjustments

Adjust major drop lengths before lifting the ceiling plate into place.
Fine adjustments can be made after installation but are easier beforehand.

Managing Support Cables

Extra support cable can be:
- Cut to length, or
- Hidden by drilling a small hole into ceiling space and pushing excess inside (often the safest option).
A small amount of silicone may be used to conceal entry points.
If unsure, leave extra cable tucked until final position is approved.

Managing Power Cables

In many cases, extra cable fits inside the ceiling plate.
If too long, open a ceiling space to tuck cables above.
This depends on drop length and ceiling type – adjust accordingly.

✅ Final Check: Before completing installation, verify drop lengths, ring balance, and orientation match your desired final look.